Whether you're planning a day at the beach or camping for the weekend, a camping canopy can provide you with shelter from the rain or a break from the bright sun for a while. One of the reasons for choosing this type of awning is that it can be set up quickly and easily with just one or two people. Below are the basic steps required to set up most tents.

The first step in building a camping canopy is finding the right location. Ideally, the ground should be as flat as possible and there should be some shelter from the wind.

Camping canopy how to build

In addition to our conventional construction methods, camping canopy can also be built into various shapes according to the changes of eyelets and camping canopy poles, and can even be used in place of tents.

(1) The first way to build: 2 camping canopy rods

The middle hole on the short side of the curtain is supported by two camping canopy rods, and the four corners of the curtain are pulled down and fixed at 45 degrees with wind ropes respectively. on-line.

(2) The second way to build: 4 camping canopy rods

The two corners of the short side of the camping canopy are directly connected to the ground and fixed, and then the middle hole of the long side and the hole at the other end are supported by the camping canopy rod. The wind rope is fixed to make the side of the camping canopy look like a 7, and it's done. Such a space is more secure, more like a comfortable living room, and the hanging curtain can also double as a projection function.

(3) The third way to build: 1 camping canopy pole

Use ground nails to strike one corner of the camping canopy first, and use camping canopy poles or camp posts to support the opposite corner. Use the wind rope on the opposite corner to pull it at a 45-degree angle, and the remaining two corners of the ground nails are ready. This way of the building makes the camping canopy closer to the tent, which can provide better protection from wind and rain. The two corners on the same side of the camping canopy are supported by the camping canopy rod, the wind rope is also pulled down at 45 degrees, and the other side of the camping canopy is nailed with two ground nails. This way of building can block the wind and sunlight from the camping canopy side well, and the effect of blocking wind and shading is very good.

(4) The fourth way to build: 2 camping canopy rods

The two corners on the same side of the camping canopy are supported by the camping canopy rod, the wind rope is also pulled down at 45 degrees, and the other side of the camping canopy is nailed with two ground nails. This way of building can block the wind and sunlight from the camping canopy side well, and the effect of blocking wind and shading is very good.

(5) The fifth way: 1 camping canopy pole

First, use the ground nails to tie the middle-end of the camping canopy, and use the camping canopy pole to support the opposite end. Pull the wind rope at 45 degrees, put ground nails in the middle of both sides, and fold the excess parts. This method can even replace a tent.

The above is the introduction to the construction method of a camping canopy, I hope it will be helpful to everyone. As a camping canopy wholesaler, Friday Camp provides high-quality camping canopy with guaranteed after-sales. If you are interested in a camping canopy, welcome to consult.